Premium Foam Cannon (For Garden Hose)

Overview:

Enhance your marine cleaning routine with our Marine Ceramics Foam Cannon for Garden Hoses. Designed specifically for yachts and boats, this foam cannon creates a rich, foamy lather that effectively lifts dirt and grime, leaving your vessel sparkling clean and well-maintained.

Ideal Uses:

• Washing and detailing yachts, boats, and other marine vessels
• Cleaning exterior surfaces, including fiberglass, gelcoat, and metal
• Pre-soaking to facilitate easier cleaning and maintenance

Elevate your marine cleaning regimen with the Marine Ceramics Foam Cannon for Garden Hoses, ensuring your vessel remains pristine and protected against the elements.

Preparation:

• Fill the foam cannon reservoir or a 5 gallon wash bucket with water. The recommended foam soap ratio is 2-4 ounces of soap per 32 ounces for the foam cannons, or 5 gallons of water for buckets.
• Adjust the soap-to-water ratio according to your preference or the level of cleaning required. It's advisable to start with a lower soap concentration and increase if needed.

Dilution:   

• Measure and add the recommended amount of "Marine Foam Cannon Soap" to the water-filled reservoir or bucket.

Mixing:     

• Gently mix or swirl the solution to ensure the soap is thoroughly distributed and dissolved in the water. Avoid creating excessive foam while mixing.

Application:  1st Wash (large contaminant removal)

• Attach the foam cannon to the pressure washer or garden hose (depending on which foam cannon you have.)
• Adjust the foam cannon settings to control the soap-to-water ratio and foam thickness based on your preference.
• Apply the soap solution evenly onto the boat's surface using the foam cannon, covering the entire area to be cleaned.
• Allow the foam to dwell on the surface for about 5 minutes to effectively loosen and lift dirt, grime, and contaminants.
• Thoroughly rinse with fresh water.

Washing:  2nd Wash  (surface detailing)

• Once the boat has been completely rinsed off, you will then apply a second coat of foam to the entire boat (or a section for larger yachts.)
• Using a soft microfiber mitt, or wash pad, gently scrub and clean the boat’s surface.
• Work section by section, ensuring thorough cleaning without allowing the soap to dry on the surface.

Rinsing:

• Rinse off the soap solution completely using a pressure washer or a hose with a gentle spray nozzle attachment.
• Ensure thorough rinsing to remove all soap residue, especially in crevices and hard-to-reach areas.

Drying:

• Dry the boat surface using a clean, soft microfiber towel, forced air device, or soft chamois to prevent water spots and damage to your ceramic coated surfaces.